Heatcraft-refrigeration-products H-IM-FP User Manual

Field Wiring ... 12Refrigeration Charging ... 13Operationa

10Refrigeration Piping1. Normally, any straight run of tubing must be supported in at least two locations near each end of the run. Long runs require

11Leak Detection And EvacuationLeak TestingAfter all lines are connected, the entire system must be leak tested. The complete system should be pressur

12Field WiringThe field wiring should enter the areas as provided on the unit. The wiring diagram for each unit islocated on the inside of the electric

13Refrigeration ChargingRefrigeration Charging1. Install a liquid line drier in the refrigerant supply line between the service gauge and the liquid s

14Operational CheckoutAfter the system has been charged and has operated for at least 2 hours at normal operating conditions without any indication of

15Preventive MaintenanceRoutine preventive maintenance of any mechanical equipment is critical to its long term reliability. During normal operation a

16Preventive Maintenance

17Preventive Maintenance

18Replacement PartsTable 3. Replacement Parts ListParts Description Part NumberCompressor Contactor - 24 Volt 2252440Compressor Contactor - 230 Volt

19Wiring DiagramDiagram 1. Typical Wiring DiagramHI PRESSURE CONTROLLO PRESSURE CONTROLCONDENSER FAN MOTORSCOMPRESSOR CONTACTOR FACTORY WIRINGUSE 60 D

2General Safety Information1. Installation and maintenance to be performed only by certified personnel who are familiar with this type of equipment.2.

20Start-up ChecklistDate of Start-upLocationCONDENSING UNITMODEL #ELECTRICAL• Check Compressor Amps for COOLER and FREEZER compressors. Should match

21Start-up ChecklistRECORDOUTDOOR TEMPERATURE ______°F. SYSTEM VOLTAGE ______Volts ______PH ______PHSystem 1 Compressor Amps ______L1 ______L2

22Notes

23Notes

2175 W. Park Place Blvd. • Stone Mountain, Georgia 30087(770) 465-5600 • Fax: (770) 465-5990www.heatcraftrpd.comSince product improvement is a continu

3Compressor Module SpecificationsTable 1. Hermetic Compressor Module Electrical Data Hermetic Compressor Compressor Data Crankcase Compressor

4HP222 1/22 1/2333 1/23 1/24 1/24 1/25 1/25 1/26222 1/22 1/2333 1/23 1/24 1/24 1/25 1/25 1/26 Model Volts Phase Hz RLA LRA MCC Watts Type Lb

5SYS. 1Figure 1.Dimensional Diagrams321System PositionOne Fan Top ViewTwo Fan Top ViewThree Fan Top ViewX = 59.00 (Single Fan Length)X = 78.00 (Two Fa

6Condensing Unit PlacementSpace and Location RequirementsThe most important consideration which must be taken into account when deciding upon the loca

7Condensing Unit RiggingRigging HolesFigure 3. Condensing Unit RiggingAdequate rigging measures must be taken to support unit weight and to protect t

8Refrigeration Piping And Line SizingRefrigeration Piping And Line SizingThe system as supplied by Heatcraft Refrigeration Products, was thoroughly cl

9Figure 5. Drain LineRefrigeration PipingSuction Lines NOTE: If the suction line must rise to the point higher than the suction connection on the